CHAPTER – 2
Hydrogen
Position of Hydrogen In The Periodic
Table
Elements are arranged in the periodic table on the basis of
their element configuration. Hydrogen resembles with three groups of periodic
table in configuration and properties which are
Group IA (Alkali Metals)
Group IV (Carbon Family)
Group VII A (Halogen)
Hydrogen and Alkali Metals
Similarities
§ Both have one electron in valence shell.
§ Both are electropositive and form positive ions i.e. H+ and Na+
etc.
§ Both are hydrated in aqueous solution as H+, Li+ and Na+ etc.
§ Both reacts with non metals to form similar type of compounds as
H2O, Na2O and HCl, NaCl etc
Dissimilarities
§ Hydrogen in gas whereas IA element are metal.
§ H+ is unstable whereas Na+, Li+ are stable.
§ Alkali metals don’t form negative ions but Hydrogen i.e. H-.
§ Hydrogen forms covalent and ionic compounds whereas alkali
metals only form ionic compounds.
§ Hydrogen exists as diatomic molecule (H2) where alkali don’t.
§ Hydrogen from neutral oxide (H2O) whereas alkali metals form
basic oxides (Na2O).
Hydrogen and Halogens (VII A)
Similarities
§ Both are gases i.e. H2, F2, Cl2.
§ Both require one electron to complete their shell.
§ Both forms negative ions as H-, Cl-, Br-.
§ Metallic hydrides (NaH) as well as metallic halides (NaCl) are
ionic.
§ Both exists as diatomic molecules i.e. H2, F2, Cl2.
§ Both forms covalent compounds with non-metals i.e. CH4, SiH4,
Ccl4.
Dissimilarities
§ Hydrogen is colourless whereas halogens are coloured gases.
§ Hydrogen has one electron in valence shell (1s(1)), whereas
halogens have seven electrons (ns2np2).
§ Halogens don’t form positive ions whereas hydrogen forms
positive ions H+.
§ H- is unstable whereas F-, Cl- are stable.
§ Hydrogen is reducing agent where halogens are oxidizing agents.
§ Hydrogen forms neutral oxides whereas halogens form acidic
oxides.
Hydrogen and Group IV A
Similarities
§ Both have half filled valence shell.
§ Both forms covalent compounds.
§ Both have same electronegativity.
§ Both have same ionization potential.
§ Both have same electron affinity.
§ Liquid Hydrogen and carbon (except graphite) are bad conductors.
Dissimilarities
§ Hydrogen is gas whereas IV A elements are metals and metalloids.
§ Hydrogen shows mono valency whereas IV shows tetra valency.
§ Hydrogen is in s-block whereas IV A elements are in p-block.
§ Hydrogen has one electron in valence shell whereas IV A,
elements have four.
§ Hydrogen does not exhibit allotropy whereas IV A elements
exhibit.
§ Hydrogen is diatomic whereas IV A are not.
Conclusion
Due to these similarities and dissimilarities, position of
hydrogen is not decided. But it is generally placed with group I A elements due
to similar electronic configuration.
Industrial Preparation of Hydrogen
1. Electrolysis of Water
When electricity is passed through water in presence of electro
hydrogen and oxygen. H2 is collected at cathode and O2 at anode.
2. From Natural Gas
When a mixture of steam and natural gas is heated upto 900ºC in
presence of Nickle, then a mixture of hydrogen and carbon monoxide called water
gas is produced.
Separation of H2 From Water Gas
Method I
Calculated amount of steam is mixed with water gas and this
mixture is passed over iron oxide or cobate oxide at 500ºC. As a result CO is
converted into CO2.
Mixture of CO2 and H2 is passed through water under high
pressure. As a result CO2 is converted to H2CO3 leaving free hydrogen gas.
H2O + CO2 + H2 —-> H2CO3 + H2 ↑
H2O + CO2 + H2 —-> H2CO3 + H2 ↑
Method II
It is the liquification method in which water gas is cooled up
to -200ºC by means of liquid air. Then CO becomes liquid and free hydrogen gas
is separated. But this hydrogen may contain traces of CO which are removed by
passing it through the solution of NaOH and pure hydrogen is obtained.
3. By the Action of Steam of Coal
When the steam is passed over red hot coke at about 10000ºC then
water gas is produced.
Separation of H2 From Water Gas
Method I
Calculated amount of steam is mixed with water gas and this
mixture is passed over iron oxide or cobate oxide at 500ºC. As a result CO is
converted into CO2.
Mixture of CO2 and H2 is passed through water under high
pressure. As a result CO2 is converted to H2CO3 leaving free hydrogen gas.
H2O + CO2 + H2 —-> H2CO3 + H2↑
Method II
It is the liquification method in which water gas is cooled up
to -200ºC by means of liquid air. Then CO becomes liquid and free hydrogen gas
is separated. But this hydrogen may contain traces of CO which are removed by
passing it through the solution of NaOH and pure hydrogen is obtained.
CO + H2 + NaOH —-> HCOONa + H2↑
4. Steam Methanol Process
When mixture of methanol vapours and steam is heated at about
250ºC then a mixture of hydrogen and carbon dioxide is produced.
CH3OH + H2O —-> CO2 + 3H2
This mixture is passed through water under high pressure. As a
result, CO2 is converted to H2CO3 leaving free hydrogen gas.
H2O + CO2 + H2 —-> H2CO3 + H2↑
5. Thermal Decomposition of
Hydrocarbon
When a hydrocarbon methane is heated at 800ºC in absence of air
or oxygen then it is decomposed into carbon black and hydrogen.
This process is called Pyrolysis or Cracking. Carbon Black is used as pigment for inks, plastics, paints, typewriter, carbon papers. It is used in rubber industry, especially as fillers for tyres.
This process is called Pyrolysis or Cracking. Carbon Black is used as pigment for inks, plastics, paints, typewriter, carbon papers. It is used in rubber industry, especially as fillers for tyres.
6. Thermal Decomposition of Ammonia
In this process liquid ammonia from cylinders is vaporized and
heated to 1000ºC then passed over an active catalyst.
The mixture of N2 and H2 is cooled to -196ºC when N2 liquefies
leaving hydrogen free.
ATOMIC HYDROGEN
Definition
The hydrogen obtained as a result of dissociation of ordinary molecular
hydrogen is known as Atomic Hydrogen.
Preparation of Atomic Hydrogen
1. Thermal Decomposition of H2
When ordinary hydrogen is heated at 5000ºC in absence of air in
a metallic tube of high melting point then it decomposes into atomic hydrogen.
2. Electrical Dissociation of H2
When high voltage electricity is passed through the molecular
hydrogen in a discharge tube at low pressure then atomic hydrogen is obtained.
Properties of Atomic Hydrogen
Usually hydrogen is found in molecular form because atomic
hydrogen is very reactive. It has only only electron in outermost shell and
requires only one electron to complete its shell. Atomic hydrogen gets their
electron from other hydrogen atom and form molecular hydrogen. Therefore, its
life period is 0.3 seconds. Some reactions of atomic hydrogen are
P + 3H —-> PH3
O2 + 2H —-> H2O2
S + 2H —-> H2S
Cl2 + 2H —-> 2HCl
CuO + 2H —-> Cu + H2O
AgCl + H —-> Ag + HCl
C2H4 + 2H —-> C2H6
Uses of Atomic Hydrogen
Atomic Hydrogen is used to prepare Atomic Hydrogen Torch which
contains a temperature of 4000ºC to 5000ºC. It is used to weld all alloys,
Nickle steels. Hydrogen gas is passed through electric are set between tungsten
filament. H2 decomposes to form atomic hydrogen which then recombines releasing
energy due to which temperature is raised to 5000ºC.
H + H —-> H2 + 104 K. Cal
Difference Between Atomic Hydrogen
& Nascent Hydrogen
Atomic Hydrogen
1. Produced as a result of dissociation of molecular hydrogen.
2. It is produced by Thermal Decomposition and electrical dissociation
of molecular hydrogen.
3. Produced at high temperature.
Nascent Hydrogen
1. Produces at the time of birth in a chemical reaction.
2. It is produced as a result of displacement reaction, when a
compound of hydrogen reacts with highly positive metal.
Zn + 2HCl —-> ZnCl2 + 2[H]
3. Produced at room temperature.
DIFFERENCES BETWEEN ATOMIC HYDROGEN
AND MOLECULAR HYDROGEN
Atomic Hydrogen
1. Methods of preparation.
2. Reactions are fast.
3. Reactions don’t require catalyst.
4. Reactions are carried out at room temperature.
Molecular Hydrogen
1. Methods of preparation.
2. Reactions are slow.
3. Reactions require catalyst.
4. Reactions are carried out at high temperature.
BINARY COMPOUNDS OF HYDROGEN
Definition
Compounds of hydrogen with other elements are called binary
compounds or Hydrides.
Types of Hydrides
There are six binary compounds of hydrogen which are
1. Ionic Hydrides
There are the hydrides of I A and II A (except Be, Mg)
General Formula = M-H+ (I A)
= M+2 H2- (II A)
Ionic hydrides, metal atom form positive ion and hydrogen atom
forms negative ion so they are also called True Hydrides.
Preparation
They are prepared by passing hydrogen gas over hot alkali metals
or alkaline earth metals.
Properties
They react with water, acids and alcohol to produce hydrogen
gas.
Na+H- + H2O —-> NaOH + H2
Na+H- + HCl —-> NaCl + H2
Na+H- + C2H5OH —-> C2H5ONa + H2
Ca+2H2- + 2H2O —-> Ca(OH)2 + 2H2
2. Covalent Hydrides
These are the hydrides of IV A to VII A. They contain covalent
bond, therefore they are called Covalent Hydrides. IV A hydrides are neutral, V
A hydrides are basic and VI A, VII A hydrides are basic.
Preparation
They are prepared indirectly as
CaC2 + 2H2O —-> Ca(OH)2 + C2H2
Al4C3 + 6H2O —-> 2Al2O3 + 3CH4
Mg3N2 + 6H2O —-> 3Mg(OH)2 + 2NH3
Ca3P2 + 6H2O —-> 3Ca(OH)2 + 2PH3
PCl3 + 3H2O —-> H3PO3 + 3HCl
3. Complex Hydrides
These are the hydrides of III A being themselves unstable
combines with IA hydrides to form complex hydrides.
Preparation
LiH + AlH3 —-> LiAlH4
NaH + BH3 —-> NaBH4
Properties
They are soluble in water and give H2
NaAlH4 —-> Al(OH)3 + NaOH + 4H2
4. Metallic Hydrides
These are the hydrides of transition metals. In these hydrides,
H2 occupies interestitial spaces (spaces between the atoms) hence, they are
also called Interestitial Hydrides.
Properties of these hydrides are those of the pure metals
therefore they are also called Metallic Hydrides.
On strongly heating, they release hydrogen in atomic state. So
they are used as catalyst in Hydrogenation reaction.
5. Polymeric Hydrides
These are the hydrides of Be and Mg of IIA which polymerize
through hydrogen bonding forming polymers hence they are represented by the
formula (BeH2)n and (MgH2)n.
Properties
These properties are intermediate between ionic and covalent
hydrides.
6. Broder Line Hydride
These are the hydrides of metals of IB, and few metals of IIIA.
Properties
Their properties are intermediate between metallic and covalent
hydrides.
Isotopes
of Hydrogen
Atoms of same element having same atomic number but different
mass number are called Isotopes. They have same number of protons but different
number of neutrons. They have same chemical but different physical properties.
Menzel in 1931 reported that neutral H2 consist of two isotopes,
Protium and Deutrium. The third is Tritium which can be obtained by the
Artificial Atomic Transmutation.
Protium (IHI or H)
§ It is ordinary Hydrogen
§ It is most abundant, about 99.98%.
§ Atomic Number = 1
§ Contians 1 electron, 1 proton and no neutron.
Deutrium (IH2 or D)
§ It is also called Heavy Hydrogen
§ It occurs about 0.015%.
§ Atomic Number = 1, Mass Number = 2
§ Contains 1 electron, 1 proton and 1 neutron.
Tritium (IH3 or T)
§ It is the heaviest isotope of hydrogen.
§ It occurs about 4×10(-15)%.
§ It is radioactive. Its half life is 12.5 years.
§ Atomic Number = 1, Mass Number = 3.
§ Contains 1 electron, 1 proton and 2 neutrons.
Behaviour of H+ and H- with Water
H+ and H- are unstable and don’t exist as such in a chemical reaction.
H+ exist in water in hydrated from as H904+.
H+ + 4H2O —-> H9O4+
H- ion reacts with water releasing H2 gas.
H- + H2O —-> H2 + OH-
Water Has High Boiling Point
Reason
This is because due to high electro negativity of oxygen atom,
water is a highly polar molecule. Due to high polarity strong intermolecular
hydrogen bonding develops among water molecule.
0 comments :
Post a Comment