Ethane C2H6
Introduction
Organic compounds which are composed,
of only carbon and hydrogen atoms are known as hydrocarbons. Those hydrocarbons
in which all the valencies of carbon atom are fulfilled by hydrogen atoms are
called Saturated Hydrocarbon or alkenes.
The second member of alkane family composed of two carbon and six hydrogen atoms and is known as Ethane.
The second member of alkane family composed of two carbon and six hydrogen atoms and is known as Ethane.
Structure of Ethane
Ethane is a saturated hydrocarbon, which
is composed of two carbon and six hydrogen atoms. Its molecular formula is
C2H6. The structural formula of ethane shows that each carbon contains three
hydrogen and single bond is present between two carbon atoms.
H3C – CH3
Each carbon atom of ethane is Sp3
hyberidized which contains four equivalent partially filled Sp3 hybrid
orbitals, these hybrid orbitals are arranged at the four corners of regular
tetrahedron (tetra hedral structure) with an angle of 109.5º.
Three Sp3 hybrid orbitals of carbon
atoms overlap with s atomic orbitals of hydrogen atoms to form a sigma bond
between C – H due to the overlapping of Sp3 – S orbitals. The remaining Sp3
hybrid of each carbon atom overlapp with the Sp3 hybrid orbital of other carbon
atom to form sigma bond between C – C due to the overlapping of Sp3 – Sp3
Diagram Coming Soon
Preparation of Ethane
Ethane can be prepared by the
following methods.
1. From Ethyl Magnesium Iodide
In presence of dry ether when alkyl
halide reacts with magnesium metal then Alkyl Magnesium halide is formed. This
compound was first synthesized by a German Chemist Grignard, therefore, it is
also known as Grignard’s Reagent.
2. From Reduction of Ethyl Iodide
When Zn – Cu couple reacts with
ethanol then nascent Hydrogen is obtained.
Zn – Cu + 2C2H5OH —-> (C2H5O)2Zn +
Cu + 2[H]
Nascent Hydrogen acts as strong
reducing agent. When methyl iodide is reduced with nascent hydrogen then
methane is formed.
C2H5l + 2[H] —-> C2H6 – Hl
3. From Hydrogenation of Ethane
Introduction of hydrogen in a
compound is called hydrogenation. In presence of catalyst Nickle, Palladium,
when ethen is heated with hydrogen at about 250ºC then hydrogenation takes
place as a result ethane is obtained.
C2H4 + H2 —-> C2H6
4. By Wurtz Synthesis
When methyl iodide is treated with
dry sodium metal, then ethane is formed, in this reaction other products are
also formed.
2CH3I + 2Na —-> C2H6 + 2NaI
Physical Properties of Ethane
1. At ordinary temperature and
pressure ethane act as colourless gas.
2. Ethane gas is sparingly soluble in
water but easily soluble in organic solvents.
3. Ethane gas is lighter then air.
4. The melting point, boiling point
and specific gravity of ethane is greater than methane.
Chemical Properties of Ethane
Reactivity
Ethane is a saturated hydrocarbon,
which is composed of two carbon and six hydrogen atoms. Its molecular formula
is C2H6. The structural formula shows that all the valencies of carbon atoms
are fulfilled by hydrogen atoms and single bond is present between two carbon
atoms. Therefore, ethane is chemically unreactive. It does not react with any
acid, base or oxidizing agents such as KMnO4 or K2Cr2O7. Under special
circumstances ethane shows only substitution reaction.
Some important reactions of ethane
are given below.
1. Halogenation
Introduction of halogen in a compound
is called halogenation. In presence of sunlight when ethane reacts with
chlorine (halogen) then chlorination (halogenation) takes place. As a result
hydrogen atom of ethane is replaced by chlorine atom to form a substituted
product, mono chloro ethane or ethyl chloride.
C2H6 + Cl2 —-> C2H5Cl + HCl
In presence of sunlight and excess
chlorine further substitution takes place till all the hydrogen atoms are
replaced by chlorine atom.
2. Combustion
When ethane is heated in presence of
air or oxygen then carbondioxide and water are formed with the evolution of
large amount of heat energy.
C2H6 + 5/2O2 —-> 2CO2 + 3H2O
Uses Of Ethane
Methane is used as fuel.
0 comments :
Post a Comment